Troubleshooting - BOMBARDIER outlander 800 Operator's Manual

TROUBLESHOOTING

ENGINE DOES NOT TURN
1. Ignition switch is in the OFF position.
–
Place switch to the ON position.
2. Engine stop switch.
–
Make sure that engine stop switch is in ON position.
3. Transmission is not set on PARK or NEUTRAL.
–
Set transmission either in PARK or in NEUTRAL or press the brake lever.
4. Burnt fuse.
–
Check main fuse condition.
5. Weak battery or loose connections.
–
Check charging system fuse.
–
Check connections and terminals condition.
–
Have the battery checked.
–
Contact an authorized Bombardier ATV dealer.
6. Wrong ignition key, speedometer multi-function display shows INVALID
KEY.
–
Use the proper key for this vehicle.
ENGINE TURNS OVER BUT FAILS TO START
1. Flooded engine (spark plug wet when removed).
–
Refer to SPECIAL PROCEDURES.
2. No fuel to the engine (spark plug dry when removed).
–
Check fuel tank level. A failure of the fuel pump may have occurred.
–
Contact an authorized Bombardier ATV dealer.
3. Spark plug/ignition (no spark).
–
Check main fuse condition.
–
Remove spark plug then reconnect to ignition coil.
–
Check that ignition switch and/or engine stop switch is/are at the ON posi-
tion.
–
Start engine with spark plug grounded to the engine away from spark plug
hole. If no spark appears, replace spark plug.
–
If trouble persists, contact an authorized Bombardier ATV dealer.
4. Speedometer CHECK ENGINE indicator lamp is on and multi-function dis-
play shows CHECK ENGINE.
–
Contact an authorized Bombardier ATV dealer.
5. Engine is under a protection mode.
–
Speedometer CHECK ENGINE indicator lamp is on and multi-function dis-
play shows CHECK ENGINE, contact an authorized Bombardier ATV dealer.
–
_____________________
93