Indicator Lamps - KTM 1290 SUPER ADVENTURE Owner's Manual

7 COMBINATION INSTRUMENT
56
7.5

Indicator lamps

Possible states
The high beam indicator lamp lights up blue – The high beam is switched
on.
The immobilizer indicator lamp lights up or flashes red – Status or error
message for immobilizer/alarm system.
The oil pressure warning lamp lights up red – Engine oil pressure is too
low.
The general warning lamp lights up yellow – An operating safety (warning)
402336-01
message was detected. This is also shown on the matrix display.
The left turn signal lamp flashes green simultaneously with the turn signal
– The left turn signal is switched on.
The idle indicator lamp lights up green – The transmission is shifted to
neutral.
The right turn signal lamp flashes green simultaneously with the turn signal
– The right turn signal is switched on.
The engine warning lamp lights up/flashes yellow – The engine control unit
has detected a fault.
The ABS lamp lights up/flashes yellow – ABS is not active. The ABS lamp
also lights up when a fault is detected.
The TC lamp lights up/flashes yellow – The motorcycle traction control is
not enabled or is currently intervening. The TC lamp also lights up when an
error is detected. In addition, the TC lamp flashes if the HHC (optional) is
active.
The cruise control system lamp lights up yellow – The cruise control system
function is switched on, but the speed control is not active.