Related Manuals for KTM 1290 Super Duke R EU 2015
Summary of Contents for KTM 1290 Super Duke R EU 2015
- Page 1 SETUP INSTRUCTIONS 2015 1290 Super Duke R EU 1290 Super Duke R AU 1290 Super Duke R FR 1290 Super Duke R CN 1290 Super Duke R US Art. no. 3213318en...
- Page 3 KTM accepts no liability for delivery options, deviations from illustrations and descriptions, misprints, and other errors.
-
Page 4: Means Of Representation
MEANS OF REPRESENTATION Symbols used The meaning of specific symbols is described below. Indicates an expected reaction (e.g. of a work step or a function). Indicates an unexpected reaction (e.g. of a work step or a function). Indicates a page reference (more information is provided on the specified page). Indicates information with more details or tips. - Page 5 SETUP Unpacking and setting up the vehicle Preparatory work – Remove the box. Main work – Remove the adhesive tape in the upper area of the motorcycle. L01494-01 – Roll down the film at the sides. Info To avoid damaging the motorcycle during unpacking, leave the other films on the vehicle until you have finished work on the vehicle.
- Page 6 SETUP – Tighten the controls on the right half of the handlebar. Guideline Remaining screws, chassis 10 Nm (7.4 lbf ft) Screw, combination switch, right 3.5 Nm (2.58 lbf ft) – Check the throttle grip for smooth operation. L01506-01 – Mount and tighten the rear mirror on both sides.
- Page 7 Plug in the connector of starter relay – Recharge the battery. ( p. 7) – Remove the protective plastic. – Refuel. ( p. 9) – Print out the current PDIform found on the KTM Dealer.net and perform the pre- delivery inspection. L01508-10...
- Page 8 WORK Removing the passenger seat – Insert the ignition key in seat lock and turn it clockwise. – Lift the passenger seat at the front and pull it out of the holder toward the front. – Remove the passenger seat. –...
-
Page 9: Recharging The Battery
The battery is maintenance-free, i.e., the acid level does not have to be checked. If the battery is not charged using the KTM battery charger, the battery must be removed for charging. Otherwise, overvoltage may damage electronic components. Charge the battery according to the instructions on the battery housing. - Page 10 WORK – Connect the battery charger to the battery. Switch on the battery charger. Battery charger (58429074000) You can also use the battery charger to test the open-circuit voltage and start potential of the battery, and to test the alternator. With this device, you cannot overcharge the battery.
- Page 11 WORK Refueling Danger Fire hazard Fuel is highly flammable. – Never refuel the vehicle near open flames or burning cigarettes, and always switch off the engine first. Be careful that no fuel is spilt, especially on hot vehicle components. Clean up spilt fuel immediately. –...
- Page 12 WORK – Lift cover of the filler cap and insert ignition key in the fuel tank lock. L01418-10 Note Danger of damage Ignition key breakage. – To take pressure off of the ignition key, push down on the filler cap. Damaged ignition keys must be replaced.
-
Page 13: Technical Data - Tightening Torques For Chassis
TECHNICAL DATA - TIGHTENING TORQUES FOR CHASSIS – EJOT PT ® Remaining screws, chassis K50x12 1 Nm (0.7 lbf ft) – Remaining screws, chassis EJOT PT ® K50x14 1 Nm (0.7 lbf ft) – Remaining screws, chassis EJOT PT ® K50x16 2 Nm (1.5 lbf ft) –... - Page 14 TECHNICAL DATA - TIGHTENING TORQUES FOR CHASSIS – Nut, shift rod 12 Nm (8.9 lbf ft) – Nut, shift rod M8LH 12 Nm (8.9 lbf ft) – Nut, valve, angled 4 Nm (3 lbf ft) – Remaining nuts, chassis 25 Nm (18.4 lbf ft) –...
- Page 15 SUBSTANCES Super unleaded (ROZ 95/RON 95/PON 91) Standard/classification – DIN EN 228 (ROZ 95/RON 95/PON 91) Guideline – Only use unleaded super fuel that matches or is equivalent to the specified fuel grade. – Fuel with an ethanol content of up to 10 % (E10 fuel) is safe to use. Info Do not use fuel containing methanol (e.
- Page 16 *3213318en* 3213318en 04/2015 KTM Sportmotorcycle GmbH 5230 Mattighofen/Austria Photo: Mitterbauer/KTM http://www.ktm.com...