MAINTENANCE WORK ON THE CHASSIS
Adjusting the chain guide
11.39
Checking the throttle cable routing
11.40
Adjusting the basic position of the clutch lever
11.41
x
–
Unscrew screw
Condition
Number of teeth: ≤ 44 teeth
–
Insert collar bushing
–
Mount and tighten screw
Guideline
Remaining screws, chassis
Condition
Number of teeth: ≥ 45 teeth
–
Insert collar bushing
–
Mount and tighten screw
Guideline
Remaining screws, chassis
B00348-10
–
Remove the fuel tank.
–
Check the throttle cable routing.
The throttle cable must be routed to the carburetor on the left side of the upper
frame tube behind the handlebars.
»
If the throttle cable is not routed as specified:
–
Correct the throttle cable routing.
–
Install the fuel tank.
601197-01
(All 125/150 models)
–
Adjust the basic setting of the clutch lever to your hand size by turning adjust-
ing screw
B00001-11
. Remove screw
. Swing the chain guide down.
in hole
. Position the chain guide.
. Tighten screw
in hole
. Position the chain guide.
. Tighten screw
(
p. 48)
x
x
(
p. 48)
.
Info
Turn the adjusting screw counterclockwise to increase the distance
between the clutch lever and the handlebar.
Turn the adjusting screw clockwise to decrease the distance between
the clutch lever and the handlebar.
The range of adjustment is limited.
Turn the adjusting screw by hand only, and do not apply any force.
Do not make any adjustments while riding!
.
M6
10 Nm
(7.4 lbf ft)
.
M6
10 Nm
(7.4 lbf ft)
53