Installing The Main Silencer; Changing The Glass Fiber Yarn Filling Of The Main Silencer - KTM 125 SX Owner's Manual

MAINTENANCE WORK ON THE CHASSIS

Installing the main silencer

11.30

Changing the glass fiber yarn filling of the main silencer

11.31
Warning
Danger of burns The exhaust system gets very hot when the vehicle is driven.
–
Allow the exhaust system to cool down. Do not touch hot components.
Info
Over a period, the fibers of the insulating material vanish into the air, and the silencer "burns out".
Not only is the noise level higher, the performance characteristic changes.
4 0 0 4
1 0 0 1
2 0 0 2
–
Remove screws
–
Pull the main silencer off of the manifold at the rubber sleeve
601184-10
–
Mount the main silencer with rubber sleeve
–
Mount and tighten screws
Guideline
Remaining screws, chassis
601184-11
–
Remove the main silencer. (
–
Remove screws
–
Pull the glass fiber yarn filling
–
Clean the parts that are to be reinstalled.
–
Mount the new glass fiber yarn filling
–
Slide outer tube
–
Mount and tighten all screws
–
Install the main silencer. (
0 0 3 3
401045-10
.


.

M6
x
p. 46)
. Pull out inside tube .
 
from the inner tube.

on the inner tube.

over the inner tube with the new glass fiber yarn filling.

.

p. 47)
.

.
10 Nm (7.4 lbf ft)
47