Adding Gear Oil - KTM 125 SX Owner's Manual

MAINTENANCE WORK ON THE ENGINE

Adding gear oil

x
17.5
Info
Too little gear oil or poor-quality oil results in premature wear of the transmission.
The gear oil must be added when the engine is cold.
Danger
Danger of poisoning Exhaust gases are poisonous and inhaling them may
result in unconsciousness and/or death.
–
When running the engine, always make sure there is sufficient ventila-
tion, and do not start or run the engine in an enclosed space without an
effective exhaust extraction system.
–
Start the engine and check that it is oil-tight.
–
Check the gear oil level. (
–
Place the motorcycle on a level surface.
(All 125/150 models)
–
Remove gear oil level check screw
B00049-10
(All 250/300 models)
–
Remove gear oil level check screw
B00050-10
–
Remove screw cap
–
Add gear oil until it flows out of the hole of the gear oil level check screw.
Engine oil (15W/50) (
–
Mount and tighten the gear oil level check screw.
Guideline
Screw, gear oil level check
–
Mount and tighten screw cap
B00053-11
Danger
Danger of poisoning Exhaust gases are poisonous and inhaling them may
result in unconsciousness and/or death.
–
When running the engine, always make sure there is sufficient ventila-
tion, and do not start or run the engine in an enclosed space without an
effective exhaust extraction system.
–
Start the engine and check that it is oil-tight.
p. 80)
.

.

.

p. 113)
M6
.

82
10 Nm (7.4 lbf ft)