MAINTENANCE WORK ON THE CHASSIS
Removing the shock absorber
11.20
Installing the shock absorber
11.21
Removing the seat
11.22
Mounting the seat
11.23
x
–
Raise the motorcycle with the lift stand. (
–
Remove screw
without blocking the rear wheel. Fix the rear wheel in this position.
–
Remove screw
absorber.
601191-10
x
–
Push splash protector
tighten screw
Guideline
Screw, top shock absorber
–
Mount and tighten screw
Guideline
Screw, bottom shock
absorber
601191-11
Info
The heim joint for the shock absorber at the swing arm is Teflon coated. It
must not be greased with grease or with other lubricants. Lubricants dis-
solve the Teflon coating, thereby drastically reducing the service life.
–
Remove the motorcycle from the lift stand. (
–
Remove screw
above.
601192-10
–
Hook in the front of the seat at the collar bushing of the fuel tank, lower at the rear
and simultaneously push forward.
–
Make sure that the seat is correctly locked in.
B00318-01
and lower the rear wheel with the swing arm as far as possible
, push splash protector
to the side and position the shock absorber. Mount and
.
M12
.
M12
. Lift up the seat at the rear, pull it back and then remove from
p. 37)
to the side, and remove the shock
80 Nm
Loctite
®
2701
(59 lbf ft)
80 Nm
Loctite
®
2701
(59 lbf ft)
p. 37)
44