SERVICE WORK ON THE CHASSIS
Removing the engine guard (SX‑F MUSQUIN REPLICA)
10.44
Installing the engine guard (SX‑F MUSQUIN REPLICA)
10.45
–
Inject the liquid into the system until it escapes from hole
without bubbles.
–
To prevent overflow, drain fluid occasionally from the master cylinder reservoir.
–
Remove the bleeding syringe. Mount and tighten screws bleeder screw.
–
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below container rim
–
Position the cover with the membrane. Mount and tighten the screws.
100925-10
–
Remove screws
101076-10
–
Attach the engine guard on the frame at the rear and swing up at the front.
–
Position the holding bracket. Mount and tighten the screws.
Guideline
Remaining screws, chassis
101077-01
4 mm (0.16 in)
and the holding bracket. Remove the engine guard.
M6
51
of the master cylinder
10 Nm (7.4 lbf ft)