Removing And Reinstalling The Rack Handles - Lenovo ThinkServer TD350 User Manual And Hardware Maintenance Manual

4. Fully open the cover handle and slide the server cover to the rear until it is disengaged from the chassis.
Then, lift the server cover off the chassis and place the server cover on a flat clean surface.
Note: It is recommended that you wait several minutes to let the server cool before removing the
server cover.
Attention: Handle the server cover carefully. Dropping the server cover with the cover latch open
might damage the cover latch.
Figure 34. Removing the server cover
To reinstall the server cover, see "Reinstalling the server cover and reconnecting cables" on page 180.
Attention: For proper cooling and airflow, install the server cover before turning on the server. Operating the
server for more than 30 minutes with the server cover removed might damage server components.

Removing and reinstalling the rack handles

Attention: Do not open your server or attempt any repair before reading and understanding "Read this first: safety
information" on page iii and "Guidelines" on page 69.
Before you begin, print all the related instructions or ensure that you can view the PDF version on another
computer for reference.
Note: The rack handles are available only on rack-form-factor server models. Depending on the model, your
server might look slightly different from the illustrations in this topic.
To remove and reinstall the rack handles, do the following:
.
Chapter 6 Replacing hardware
73