Lenovo ThinkServer TD350 User Manual And Hardware Maintenance Manual page 60

4. Connect the dual-in connectors on one end of the second Y cable to the PCI-E 0 connector and the
PCI-E 1 connector on adapter 0.
5. Connect the single connector on the other end of the second Y cable to the PCIE connector on the
PCIE interposer card.
6. Use the I2C to I2C signal cable to connect the I2C connectors on the PCIE interposer card and the
system board. Ensure that the I2C connector with the triangle on one end of the cable is connected to
the I2C connector on the system board. The triangle must face the front of the server.
To locate the connectors, refer to the related topics in "Locations" on page 17.
Connecting the SATA signal cable from the system board to the Lenovo ThinkServer
RAID 110i AnyRAID Adapter
This topic applies only to server models that have a Lenovo ThinkServer RAID 110i AnyRAID Adapter
installed.
To connect the SATA signal cable from the system board to the Lenovo ThinkServer RAID 110i AnyRAID
Adapter, do the following:
1. Use one SATA signal cable. Connect one end of the SATA signal cable to the SATA connector 0–3 and
the SATA connector 4–7 on the Lenovo ThinkServer RAID 110i AnyRAID Adapter.
2. Connect the other end of the SATA signal cable to the SATA connector 0 and the SATA connector 1
on the system board.
To locate the connectors, refer to the related topics in "Locations" on page 17.
Connecting the easy-swap-drive module to the system board
This topic applies only to server models that come with an easy-swap-drive module.
To connect the easy-swap-drive module to the system board, do the following:
1. Connect the signal cable of the easy-swap-drive module to the SATA connector 0 and SATA connector 1
on the system board.
2. Connect the power cable of the easy-swap-drive module to the backplane power connector 1 on
the system board.
To locate the connectors on the system board, see "System board components" on page 47.
46
ThinkServer TD350 User Guide and Hardware Maintenance Manual