Replacing The Anyraid Adapter - Lenovo ThinkServer TD350 User Manual And Hardware Maintenance Manual

8. Ensure that the screw holes in the new ThinkServer RAID Super Capacitor Module with the bracket
are aligned with the corresponding stubs in the chassis. Then, install the screw to secure the new
ThinkServer RAID Super Capacitor Module with the bracket in place.
Figure 126. Installing the ThinkServer RAID Super Capacitor Module with the bracket on the chassis
9. Connect the cable to the new ThinkServer RAID Super Capacitor Module.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the replacement procedure, go to "Completing the parts replacement" on page 180.

Replacing the AnyRAID adapter

Attention: Do not open your server or attempt any repair before reading and understanding "Read this first: safety
information" on page iii and "Guidelines" on page 69.
This topic applies only to server models that have an AnyRAID adapter installed.
Before you begin, print all the related instructions or ensure that you can view the PDF version on another
computer for reference.
Notes:
• Depending on the model, your server or the AnyRAID adapter might look different from the illustrations in
this topic.
• Use any documentation that comes with the AnyRAID adapter and follow those instructions in addition to
the instructions in this topic.
To replace the AnyRAID adapter, do the following:
Attention: Replacing the AnyRAID adapter might impact your RAID configurations. Back up your data
before you begin to avoid any data loss due to a RAID configuration change.
1. Remove all external media from the drives and turn off all attached devices and the server. Then,
disconnect all power cords from electrical outlets and disconnect all cables that are connected to
the server.
.
Chapter 6 Replacing hardware
159