Removing A Pcie Card - Lenovo ThinkServer TD350 User Manual And Hardware Maintenance Manual

11. Close the latch for the PCIe card slot to secure the installed PCIe card.
Figure 54. Closing the latch for the PCIe card slot
12. Depending on the type of the PCIe card, you might need to connect any required cables. Refer to the
documentation that comes with the PCIe card for specific information.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation, go to "Completing the parts replacement" on page 180.
• If you are installing an Ethernet card, continue to install the Ethernet card driver. This step is not required
if the operating system was installed using the Lenovo ThinkServer Deployment Manager program. To
install the Ethernet card driver manually, visit the Lenovo Web site at http://www.lenovo.com/drivers and
follow the instructions on the screen.
• If you are installing a RAID card, do the following:
1. Configure RAID for your server. See "Configuring RAID" on page 65.
2. Check the version of the new RAID card firmware by pressing Ctrl+H when starting the Setup
Utility program.
3. Go to http://www.lenovo.com/drivers and follow the instructions on the Web page to download the
latest version of firmware. Then, install the firmware to your server.

Removing a PCIe card

Attention: Do not open your server or attempt any repair before reading and understanding "Read this first: safety
information" on page iii and "Guidelines" on page 69.
Before you begin, print all the related instructions or ensure that you can view the PDF version on another
computer for reference.
Notes:
• Use any documentation that comes with the PCIe card and follow those instructions in addition to
the instructions in this topic.
• Depending on the specific type, the PCIe card might look different from the illustrations in this topic.
.
Chapter 6 Replacing hardware
93