Removing And Reinstalling The Rack Handles - Lenovo ThinkServer RD630 Hardware Maintenance Manual

Notes:
• Use only parts provided by Lenovo.
• Depending on the model, your server might look slightly different from the illustrations in this topic.
The EMI integrity and cooling of the server are protected by having all drive bays and PCI card slots covered
or occupied. When you install an internal drive or a PCI card, save the EMI shield or dummy tray from the
drive bay or save the PCI card slot bracket in the event that you later remove the device.
Attention: An unoccupied drive bay or PCI card slot without a cover, shield, dummy tray, filler, or any
other protection might impact the EMI integrity and cooling of the server, which might result in overheating
or component damage.

Removing and reinstalling the rack handles

Attention: Do not open your server or attempt any repair before reading and understanding "Safety information"
on page iii and "Guidelines" on page 71.
This topic provides instructions on how to remove and reinstall the rack handles.
Before you begin, print all the related instructions or ensure that you can view the PDF version on another
computer for reference.
Note: Depending on the model, your server might look slightly different from the illustrations in this topic.
To remove and reinstall the rack handles, do the following:
1. On each side of the server, remove the screw that secures the rack handle and then remove the rack
handle from the chassis.
Figure 39. Removing the rack handles
.
Chapter 6 Installing, removing, or replacing hardware
77