Ricoh MET-C1 Field Service Manual page 188

2. Installation
2. SD card slot cover [A] ( ×1).
3. Set the destination SD card (SD card where data is to be stored) in Slot 1 [A], and set the
original SD card (SD card from which data is to be transferred) in Slot 2 [B].
4. Turn the power on, and press [ENTER] in SP5-873-001 (SD Card Appli Move: Move
Exec).
5. When a confirmation screen is displayed, press [ENTER] (it takes about 2 - 3 minutes).
• If [CANCEL] is pressed, the display returns to the previous screen.
• Note that if the power supply is turned off, a panel operation is performed, or the cover is
opened during merge, it will result in a malfunction.
6. When merge is complete, and the following screen is displayed, press [CLOSE].
• If the process is terminated abnormally, perform the merge in SP mode again.
• If the capacity of the destination SD card is insufficient, the merge operation cannot be
performed.
186