Ps/2 Mouse Port; Parallel Port; Floppy Disk Drive Controller - DFI G586IPC User Manual

serial port cable should be used for the COM 2 secondary serial port;
connect it to connector J3 on the system board. Make sure the colored
stripes on the ribbon cables are aligned with pin 1 of connectors J2 and
J3. Mount the card-edge bracket to the system chassis.

PS/2 Mouse Port

The PS/2 mouse port is a 6-pin connector on the system board. Attach
the 6-pin mouse port cable, which came with the G586IPC, to connector
J1. Make sure the brown wire on the PS/2 mouse connector is aligned
with pin 1 of connector J1.

Parallel Port

The G586IPC system board has a standard connector for interfacing
your PC to a parallel printer. The parallel port on your system board can
be set to any of the following system I/O addresses:
I/O Address: 3BC-3BE Hex
Connecting the Parallel Printer Port
Attach the DB-25S printer port cable, which came with the system
board, to connector J5 on the G586IPC system board. Make sure the
colored stripe on the ribbon cable aligns with pin 1 of connector J5. Use
a small nutdriver to mount the cable into a DB-25 cutout in the system
chassis.

Floppy Disk Drive Controller

The G586IPC system board has a built-in floppy disk controller that
supports two standard floppy disk drives. You can install any 360KB,
720KB, 1.2MB, 1.44MB, or 2.88MB floppy disk drives.
Connecting the Floppy Disk Cable
1. Install the 34-pin header connector into the floppy disk connector
(J4) on the system board. The colored edge of the ribbon should be
aligned with pin 1 of connector J4.
378-37A Hex (default)
278-27A Hex
23