Vertical And Horizontal Position - Christie DS+5K User Manual

Section 2: Installation and Setup
2-6 User's Manual
Downloaded From projector-manual.com Christie Manuals

Vertical and horizontal position

The correct vertical and horizontal position of the projector in relation to the screen
depends on the lens type and the screen size. Ideally, the projector should be
positioned perpendicular to the screen. This way, the image will appear rectangular
instead of keystoned (trapezoidal).
The vertical position of the image can be offset – that is moved above or below the
optical axis (lens center) by adjusting the fully motorized lens mount with the keypad.
The amount of vertical offset available depends directly on the lens installed in the
projector and can be slightly limited if horizontal offset has been applied. Vertical
offset can also be expressed as the percent of half the image height OR the number of
pixels of shift from lens center. Refer to Figure 2.1 for some illustrated examples of
vertical offset.
Table 2.1 along with Figure 2.2 show the maximum vertical offset of a lens or
alternatively, how much of your projected image will appear above or below lens
center if the maximum vertical offset is applied using that lens.
Table 2.1. Lens Offsets
Lens Type Vertical Offset
(% of Half Height)
%
0.73:1 fixed 37%
1.2:1 fixed (1m-3m) Info not yet available
1.2:1 fixed (3m-15m) 100%
1.45-1.8:1 zoom 100%
1.8-2.5:1 zoom 100%
2.5-4.5:1 zoom 100%
4.5-7.3:1 zoom 100%
NOTES: 1) Offsets are subject to
100.
Maximum amount of
projected image above or
below lens center
Pixels % Pixels
+/-196 69% +/-721
+/-525 100% +/-1050
+/-525 100% +/-1050
+/-525 100% +/-1050
+/-525 100% +/-1050
+/-525 100% +/-1050
±
7% centering tolerance 2) % Offset = # pixels of offset / half panel resolution x
Horizontal Offset Maximum amount of
(% of Half Width) projected image to one side
of lens center
% Pixels %
22% +/-153 61%
50% +/-350 75%
50% +/-350 75%
50% +/-350 75%
50% +/-350 75%
50% +/-350 75%
Pixels
+/-853
+/-1050
+/-1050
+/-1050
+/-1050
+/-1050