Christie DS+5K User Manual page 106

Section 4: Maintenance
4-8 User's Manual
Downloaded From projector-manual.com Christie Manuals
Improper installation could cause a serious
7. LOCK IN THE NEW LAMP MODULE
Pull out and turn the lamp lock lever (turned up in Step 4) ¼ turn clockwise to
"lock" the lamp in place.
NOTE: If you can't turn the lamp lock into position, it is likely the lamp is not
fully inserted. In this case, partially remove the lamp and try pushing it back in
again. Then, try switching the lock lever to the "lock" position.
8. REPLACE THE LAMP DOOR
Replace the lamp door and secure it with the two (2) screws removed in Step 2.
The lamp module is calibrated for maximum performance
and brightness in this projector. Do not attempt to re-
9. RECORD THE SERIAL NUMBER OF THE NEW LAMP
Plug in the projector and power it up.
In the Lamp menu, select "Change Lamp".
In the Lamp S/N text box, enter the serial number.
Press to record the number and to reset the lamp timer. The timer will
now begin to log time for the new lamp.
If you neglect to enter a serial number, the lamp timer will
not reset to "0" and will therefore be inaccurate. The lamp
life limit may then expire prematurely.
WARNING
meltdown inside the projector.
IMPORTANT
align or adjust the lamp module.
IMPORTANT