Christie DS+5K User Manual page 46

Section 3: Operation
Before You Begin
Size and Position Menu
3-20 User's Manual
Downloaded From projector-manual.com Christie Manuals
NOTES: 1) To hide these "direct" slide bars, disable the "Display Slide bars"
checkbox in the Menu Preferences menu. 2) To hide the entire menu system from
view, turn off the on-screen display by pressing
'
Use Auto Setup (
Auto
For a good and efficient first step in perfecting the image, press
automated process in which the projector quickly optimizes critical display parameters
such as size, position, pixel tracking, etc., based on the type of incoming source data
detected. An Auto Setup can save considerable setup time, and you can still modify
the adjustments as desired using menu options described below.
In the Size and Position menu, you
'
can increase or decrease the size of
your image, change its proportion
(aspect ratio), move the image to a
specific area of the screen, and
refine other related parameters. Use
Size and Position controls to match
the image precisely to the screen
used at the site.
Refer to "Using Slide bars and
Other Controls" (earlier in this
section) if you need help using any of the options and controls. Changes made in the
Size and Position menu are applied immediately and are saved when you exit the
menu (press or
Exit
Resize Presets
NOTE: The same resize presets are available to all HD2 widescreen models. Please
note however, the graphics used to describe each preset in this section are of the
SXGA+ models only.
Select a Resize Presets option
to quickly display an image in
its native resolution or to
automatically resize an image
to closely fill the projector's
native resolution or to optimize
the width or height of your
display. Size, Position and
Blanking parameters will
automatically adjust
accordingly or, if Blanking is set first, which defines an Active Input Area, Resize
Preset scaling will occur in this region of interest only. Resizing options are explained
in detail below.
WHAT IS THE RESIZING DEFAULT?
image will utilize as much of the projector's display area as possible for the type of
incoming source data, but with minimal or no changes to aspect ratio. See Select
"Default" below.
)
).
Menu
By default when displaying a new source, your
.
OSD
. This initiates an
Auto