Tcp/Udp Switch; Reset; Configure Parameters By Usb; Gprs Setting - Coban GPS102B User Manual

5.36 TCP/UDP Switch

Command: "gprs+password,0,0" TCP with keep alive data, this is the default mode.
Command: "gprs+password,1,0" TCP without keep alive data
Command: "gprs+password,0,1" UDP with keep alive data
Command: "gprs+password,1,1" UDP without keep alive data

5.37 Reset

Send SMS "reset+password" to tracker, it will reply " reset ok", the GSM and GPS module of the
tracker will be reset.

5.38 Configure parameters by USB

Find the USB cable in the package to connect tracker with computer, open the memory of the tracker,
find and open the initial configuration file with notepad , operate according the
instructions.
Note: Correct password is needed every time you configure the tracker.
.

5.39 GPRS setting

User must send SMS via cell phone to set up APN,IP and port before starting GPRS.

5.39.1 Setting up APN

5.39.1.1 APN standards for Access Point Name and differs from country to country. For more
information about the local APN, inquire with your local GPRS network operator.
5.39.1.2 Text the tracker a SMS "APN+password + Space + your local APN" via a cell phone and if
succeeded in setup, the tracker will return the message "APN OK".
5.39.1.3 e.g. send SMS command "APN123456 CMNET". If succeeded, "APN OK" is returned by
the tracker in SMS.
Notes: 123456 refer to password of tracker and CMNET is the APN of China Mobile (One of GSM
Operator in china).
5. 39.2 GPRS User ID and password Setup
5.39.2.1 In most countries, the user name and password involving GPRS login are not compulsorily
necessary, therefore, the entry can be skipped. For those countries requiring user name and password,
please configure as following:
5.39.2.2 Send SMS "up+password+space+user+space+password"If succeeded,
"user,password ok" is returned by the tracker in SMS.
17