Initialization; Change The Password; Authorization - Coban GPS102B User Manual

5.3.4 When this unit receives GPS signals normally, you can use it and do any setting as the
instructions of this manual.
5.3.5 Status indicator: The green indicator keep flashing 1 time every second after acquire GSM
signal; and every 3 seconds under GPRS state.
The red indicator keeps on when charging and turn off after fully charged.
The blue indicator keep flashing 1 time every second after acquire GPS signal.

5.4 Initialization

Send "begin+password" in SMS to the unit, it will reply "begin ok" and initialize all the settings.
(Default password: 123456)
For example, send SMS "begin123456" to the tracker via a cell phone, if succeeded, if will reply
"begin ok".

5.5 Change the password

5.5.1 Set Password: Send sms: "password+old password+space+new password" to the unit to change
the password.
For Example, pls send sms: "password123456 888888" to terminal device, it will reply sms:
"password OK". New password 888888 changed in success.
5.5.2 Be sure to keep the new password in mind, you have to upload the software to restore the
original setting in case of losing the new password.
5.5.2 Attention: Make sure the new password is in 6 digits Arabic numbers, or else the tracker cannot
recognize the password.
5.5.3The "+" in the command, please don't type "+", space means press the space keyboard on your
cell phone.

5.6 Authorization

There are 5 numbers to be allowed to authorize in the tracker at most. Be sure to set the authorization
phone number before use. Only after setting the authorization phone number can receive SMS alarm
and call the authorization phone number by SOS button on tracker.
5.6.1 Call the tracker for 10 times continuously and get position correctly, then it will make the cell
phone number as the authorized number automatically.
5.6.2 Send SMS："admin+password+space+cell phone number" to set up a authorized number. The
other authorized numbers should be set by the first authorized number. If the number is
6