Install Log Set; Appliance Operation - Heat & Glo MEZZO-1000-AU Installation Manual

Figure 11.10 Media Installed.
Fogging Option
8. If desired, the media can be fogged using a high tem
perature black paint. See below for fogging tips. Prior
to painting, take precautions to prevent any overspray
from reaching the pilot assembly.
 Apply paint with the LED lights turned on. This will
help you avoid over fogging or under fogging.
 Reduce the lighting in the room while applying the paint.
 Fog the media to the desired look.
Figure 11.11 Fogging the Media
9. Place the glass frame assembly back on the
appliance according to the instructions provided in the
appliance installation manual. Assure that there is no
media between the glass and the firebox. Media in
this area will prevent the glass gasket from sealing.
10. Install bottom glass trim between glass and glass
frame. See Figure 8.
Heat & Glo • MEZZO-1000-AU, MEZZO-1300-AU, MEZZO-1300ST-AU, MEZZO-1600-AU Installation Manual • 2304-970 Rev. D • 3/15
Figure 11.12 Install Bottom Vanity Panel
-
TROUBLESHOOTING
After the initial start up burn, it may be necessary to adjust
the media placement to achieve the best flame appearance.
While flame height variation is normal, there may appear to
be higher peaks in some areas and low flame peaks in other
areas.
If the flame height appears to be excessively high in some
spots, applying more media to these areas on top of the
burner will help even out the flames. Spreading the media as
evenly as possible is the most effective way to achieve
optimal flame appearance and the most even flame heights.
One or more test burns may be required to watch the flames
mature and see how even they look before making
adjustments.
Avoid using media pieces larger than two inches in diameter,
these can be disruptive to the flame patterns. If you find exra
large media pieces, discard.
F. Install Log Set
An optional log set is available for use with the MEZZO-AU
models. Install the log set per instructions included with kit.
G. Appliance Operation
Start the appliance to verify proper function and
installation. See the appliance Owner's Manual for IPI
lighting instructions.
Appliance ON/OFF
Use the IntelliFireTM Plus Remote Control to control the
ON/ OFF function of the appliance. Follow instructions
included with the installed control. If a wall switch is
installed, refer to the instructions included with the control.
LED Lighting
The ON/OFF function for the LED lighting option is
controlled by the IntelliFire
Follow instructions included with the installed control to
test the LED lighting.
TM
Plus remote control.
53