Wiring Requirements - Heat & Glo MEZZO-1000-AU Installation Manual

B. Wiring Requirements
TM
IntelliFire Plus Ignition System Wiring
 Wire the appliance junction cord to 220/240 VAC
for proper operation of the appliance.
WARNING! Risk of Shock or Explosion! DO NOT wire
IPI controlled appliance junction cord to a switched cir-
cuit. Incorrect wiring will override IPI safety lockout.
 Refer to Figure 8.4, IPI Wiring Diagram.
 This appliance is equipped with an IntelliFire
control valve which operates on a 6 volt/1.5 AMP system.
 Plug the 6 volt transformer plug into the appliance junction
cord to supply power to the unit OR install 4 AA cell
batteries (not included) into the battery pack before use.
NOTICE: Batteries should only be used as a power source
in the event of an emergency power outage. Batteries
should not be used as a primary long-term power source.
Battery polarity must be correct when installing batteries.
When using batteries as a power source, the 6-volt
transformer must be unplugged from the receptacle.
Do not store batteries in the battery pack when the
appliance is powered by the 6 volt transformer connected
to permanent electrical service.
TO JUNCTION
CORD (220/240V)
O R A N G E
( P I L O T )
Figure 8.4 IntelliFireTM Plus Wiring Diagram with Remote
Heat & Glo • MEZZO-1000-AU, MEZZO-1300-AU, MEZZO-1300ST-AU, MEZZO-1600-AU Installation Manual • 2304-970 Rev. D • 3/15
38
TM
FLAME
SENSE
MO D UL E
I
S
FLAME
MODULATION
R E D
BLACK
BRO WN
G R E E N
( M A I N )
GROUND
BATTERY PACK
6V DC
Accessories Requirements
 This appliance ships standard with a remote control.
Wiring for optional Hearth & Home Technologies approved
accessories should be done now to avoid reconstruction.
Follow instructions that come with those accessories.
The junction cord, control module, LED power supply
and wall switch receiver can be accessed by removing
the vanity panel and component heat shield. The
decorative front must be removed to access these
Plus
components. See Figure 8.2.
CAUTION! Risk of Overheating! Component heat shield
MUST be installed before operating appliance. Electrical
components will be damaged.
IGNITER
AUX300 MODULE
F A N
AUX 1 AUX 2
Heat Zone
CORD ADAPTER
LED CONTROL
RC300 4.5V
DC (AAA X 3)
TO JUNCTION CORD
(220/240V)
LED LIGHT TRAY