Option Descriptions - CrimeStopper LC-1 Installation Instructions Manual

Low current

Hide thumbs

Table Of Contents

Table of Contents

Smart Phone baud rate

Reset Options to Default (*)

1. Engine Monitoring:

This option controls how the system monitors the engine running. You can program for Tachless mode that monitors

battery voltage, Tach mode in which the unit uses a Tach signal (RPM) or for Timed Crank as an alternative. There are 4

choices for this option:

1. Engine R.P.M. (Tach) - Most reliable method. Tach must be programmed for this option to work.

2. Tachless Mode - Default. When vehicle is remote started, the battery voltage rate will go up because the

Alternator starts working. The Tachless Mode is adjustable in 1% increments thru Option 21.

3. Blank – No Function

4. Hybrid Mode – For electric motors that are computer controlled. This provides a 4.0 second crank output to

activate the start sequence on Hybrid vehicle. Don't use on vehicles with gas or diesel engine, doesn't monitor

engine running or low battery voltage. Option #18 allows you to shorten starter crank time if necessary.

2. AUTO LOCK and UNLOCK with IGNITION:

This feature controls whether the doors will automatically lock when the ignition is turned on and unlock when the ignition

is turned off. If the system is in Tach mode, then the doors will lock as the engine RPM's increase (driving). Some vehicles

already have this feature from the factory you should turn off this option. Doors will not lock if they are open to prevent

locking the keys in. There are 2 choices:

1. OFF = No Lock or Unlock with ignition.

2. Ignition ON = Lock, Ignition OFF = Unlock - Default.

3. DOOR LOCKS:

This option sets how the door lock circuit works. There are 4 choices:

1. 3 Second Lock and Unlock - For older European vehicles that require a long lock and unlock pulse to operate

Vacuum door lock systems.

2. 0.8 Second Lock and Unlock - Default.

3. Double Unlock – This feature may be required to interface with a factory alarm or keyless entry system. The first

pulse disarms the factory alarm; the 2

4. "Wake Up" pulse on Unlock - 0.8 second unlock pulse along with Ignition, Disarm and (-) RUN to wake up a BCM.

This feature may be required to interface with a factory alarm or keyless entry system.

9600 (MS-3)

Reset Options 1 thru 25 (2 Flashes)