Remote Start Diagnostics; Data Port - CrimeStopper LC-1 Installation Instructions Manual

REMOTE START DIAGNOSTICS

If the system flashes the LED and Parking Lights one to seven times and doesn't attempt remote. The LED will
continue to flashing the error code until the ignition is turned on, it means the following:
1 Parking Light Flash (1 LED Flash) = Problem with Brake Switch.
2 Parking Light Flashes (2 LED Flashes) = Problem with Hood Switch.
3 Parking Light Flashes (Solid LED) = Valet Service Mode.
5 Parking Light Flashes (5 LED Flashes) = Ignition On before Remote Start or Tach problem.
6 Parking Light Flashes (6 LED Flashes) = Tach Problem (Tach signal without engine running)
7 Parking Light Flashes (7 LED Flashes) = Manual Transmission Error.
Note: In Manual Transmission Mode, the LED will flash 3 times if the parking park is not set.

DATA PORT

This unit includes 3 Data Ports. The white plug is for a Smart Phone Modem (115200 and 9600 Baud rate, Option 26). There
There are 2 types of Protocol for bypass modules, Fortin EVO-SL series and OFA
are 2 Data Ports for Bypass Modules.
- ADS iDataLink series. The default is set for EVO-SL series Protocol. Please refer to Databus module manual for
detail instructions. The Data Port Protocol must be programmed for the correct module.
See Option # 5 on page 14 for programming Data Port
Some vehicles require a Databus Module to Bypass the factory Immobilizer and operate the keyless entry
Databus modules are used to communicate with the vehicles computer at the OBD2 Data connector or Canbus wires.
This reduces installation error. Crimestopper Systems with DP Series have a direct Data Port Plug-In for the Databus
bypass module. This eliminates conventional wiring between the Alarm/Remote Starter and the bypass interface
module.
www.crimestopper.com
Phone (800) 998-6880
FAX (805) 581-9500
© 2014Crimestopper Security Products
24