Table of Contents
Advertisement
INSTALLATION & OPERATING INSTRUCTIONS
CONGRATULATIONS on your choice of a Remote Keyless Entry System by Crimestopper Security Products
Inc. This booklet contains the information necessary for installing, and using your system. If any questions
arise, contact your installation dealer or Crimestopper Security Products Inc. at the Tech Support number
below.
*IMPORTANT INFORMATION: Primary and Optional Features
-PRIMARY: These are features that must be connected in order for the system to operate properly i.e. Power,
Ground, Lights, Power Locks, etc.
-OPTIONAL: Optional features are connected only if desired or agreed upon by the installing dealer i.e. Horn
Honk, Dome light illumination, Starter Kill, L.E.D., Trunk Pop, etc. These features may require additional parts
and labor charges. Consult with your installer about these features before installation.
TECH SUPPORT
Mon-Fri 8:00 AM-4:30 PM Pacific Time
(800) 998-6880
www.crimestopper.com
email@crimestopper.com
REV. B 5.01
REMOTE KEYLESS ENTRY SYSTEMS
CS-845RKE / CS-855RKE
INTRODUCTION
This device complies with FCC Rules part 15. Operation is subject to the
following two conditions: 1) This device may not cause interference, and (2)
this device must accept any interference that may be received, including
interference that may cause undesired operation. The manufacturer is not
responsible for any radio or TV interference caused by unauthorized
modification to this equipment. Such modification could void the user's
authority to operate the equipment.
Advertisement
Table of Contents
Related Manuals for CrimeStopper CS-845RKE
Summary of Contents for CrimeStopper CS-845RKE
- Page 1 CONGRATULATIONS on your choice of a Remote Keyless Entry System by Crimestopper Security Products Inc. This booklet contains the information necessary for installing, and using your system. If any questions arise, contact your installation dealer or Crimestopper Security Products Inc. at the Tech Support number below.
-
Page 2: Installation Cautions & Warnings
INSTALLATION CAUTIONS & WARNINGS BEFORE BEGINNING, check all vehicle manufacturer cautions and warnings regarding electrical service (AIR BAGS, ABS BRAKES, AND BATTERY). DO NOT ROUTE ANY WIRING THAT MAY BECOME ENTANGLED with brake, and gas pedals, steering column, or any other moving parts in the vehicle. REMOVE MAIN SYSTEM FUSE(S) before jump starting the vehicle or charging the battery at high boost. - Page 3 European vehicles require separate right and left circuits. Use a dual relay or 2 diodes to separate the output signal. WIRING CS855RKE MODULE *NEGATIVE DOME POSITIVE DOME *DEFAULT SETTING IS NEGATIVE NOTE: DOES NOT APPLY TO CS-845RKE SIDE VIEW JUMPER PLUG JUMPER PINS...
- Page 4 GREEN: (-) Negative LOCK pulse RED: +12V Coil Power for external relays (Term. 86). BLUE: (-) Negative UNLOCK pulse CS-845RKE NEGATIVE TRIGGER DOORLOCK WIRING GREEN BLUE CS-845RKE REV. POLARITY DOOR LOCK WIRING GREEN BLUE MASTER SWITCH CS-845RKE POSITIVE TRIGGER DOORLOCK WIRING...
- Page 5 CS-855 RKE POWER DOOR LOCK WIRING 3 PIN (WHITE): DOOR LOCK OUTPUT PLUG GREEN: (-) Negative LOCK pulse / (+) Positive UNLOCK pulse RED: +12V Coil Power for external relays (Term. 86). BLUE: (-) Negative UNLOCK pulse / (+) Positive LOCK pulse CS-855 RKE NEGATIVE TRIGGER DOORLOCK WIRING GREEN BLUE...
-
Page 6: Negative Trigger Door Locks
CS-845/855 SEPARATE DRIVER’S DOOR UNLOCK DIAGRAMS REVERSE POLARITY DOOR LOCKS VIOLET GREEN BLUE DRIVER'S DOOR MOTOR 30 87A UNLOCK WIRE NEGATIVE TRIGGER DOOR LOCKS VIOLET GREEN BLUE DRIVER'S DOOR MOTOR UNLOCK WIRE FACTORY LOCK RELA YS +12V + FUSED FUSED +12V... -
Page 7: Transmitter Programming
1. Turn Ignition ON and OFF 3 times quickly, leaving it ON the 3 once and one horn chirp. 2. Push the Program/Override Button for 5 seconds until you hear 3 horn chirps and lights flash 3 times. Release the Button. -
Page 8: Option Programming
To change programmable options: 1. Turn the Ignition ON, wait one second, and press the Override/Program button 5 times. 2. The system should flash the parking lights 8 times in quick succession. 3. Within the next few seconds, press the Override/Program button [again] the number of times that corresponds to the options chart below. -
Page 9: Operation
OPTION PROGRAMMING cont. 6. IGNITION TRIGGER This option controls the unit’s optional Ignition trigger feature. If selected to ON, then the vehicle’s horn will honk if an unauthorized operator turns on the Ignition after the vehicle had been locked with the remote. This function is similar to an alarm system. - Page 10 External Relays for use with Power Trunk Release Power Door Locks, Starter Disable etc. OPERATION CS-6500 DLI Plug-in Door Lock pulse inverter for CS-845RKE installation into vehicles with Positive Door lock systems. XX-SRS / XX-DRS Pre-wired plastic relay sockets for single or dual relay installation...
- Page 11 FUSE IGN. SW ACTIVATES ON 2nd PRESS OF UNLOCK BUTTON TO FACTORY HORN RELAY YELLOW +IGN SW ITCHED "ON" VIOLET (-) PASSENGER UNLOCK OUTPUT BLUE (-) HORN OUTPUT RELAYS NOT GREEN INCLUDED (-)AUX OUTPUT #2 (-) AUX OUTPUT (TRUNK POP) IGNITION "ON &...