Din Rear-Mount (Method B); Detachable Control Panel (D.c.p.) - Hyundai CRM 2108 SU Instruction Manual

DIN REAR-MOUNT (METHOD B)

Installation using the screw holes on the sides of the unit. Fastening the unit to the factory radio
mounting bracket.
1) Select a position where the screw holes of the brac-
ket and the screw holes of the main unit become
aligned (are fitted) and tighten the screws at 2 places
on each side.
2) Screw
3) Factory radio mounting bracket.
4) Dashboard or Console
5) Hook (Remove this part)
6)
Note: the mounting box, outer trim ring, and half-sleeve
are not used for method B installation.

3. DETACHABLE CONTROL PANEL (D.C.P.)

Removing The Detachable Control Panel (D.C.P.).
1) Turn the power off
2) Press the D.C.P. release button
3) Remove the D.C.P.
Attaching theDCP
1) Attach the panel at the right side first, with point B on the main unit touching point A on the
D.C.P. (As shown on the digram).
2) Then press the left side ofD.C.P. onto the main unit until a click sound is heard.
CAUTION
• DONOTinsert theD.C.P from the left side. Doing so may damage it.
• TheD.C.P can easily be damaged by shocks. After removing it, place it in a protective case
and be careful not to drop it or subject it to strong shocks.
• When the release button is pressed and the D.C.P is unlocked, the car's vibrations may cau-
se it to fall. To prevent damage to theD.C.P, always store it in a protective case after deta-
ching it.
• The rear connector that connects the main unit and theD.C.P is an extremely important part.
Be careful not to damage it by pressing on it with fingernails, pens, screwdrivers, etc.
EN - 66