Table of Contents
Advertisement
file:///C|/Documents%20and%20Settings/POpitz/My%20Documents/temp/UnidenManBeta/EDACSSCATSystems.html
EDACS SCAT Systems
Please note that these pages are meant as general instructions. While most of the information here applies to all scanners, some options may not be available on
certain scanner models. Model-specific options are indicated in the text.
This section deals with EDACS SCAT systems.
RadioReference:
150 px
And here is a
conceptual layout diagram
Programming an EDACS SCAT System
Create a system
System properties
Create a site
Site properties
Create at least 1 frequency
Frequency properties
Programming an EDACS SCAT System
To program an EDACS SCAT system, you'll need to program the required elements in following order
Create a system
1. Go to the
Program System
2. The scanner will prompt you for the System Type. Select EDCS .
3. The scanner will prompt you for the sub-type. Select SCAT .
4. When the scanner prompts you confirm, tap YES .
5. The scanner creates the system with a default name. Select
6. If you need to change any of the system properties, you can do that now. Unless a property is Required , you can operate the system without changing the default settings.
System properties
All of these options can be found under your scanner's
Property
None
file:///C|/Documents%20and%20Settings/POpitz/My%20Documents/temp/UnidenManBeta/EDACSSCATSystems.html (1 of 3)4/7/2009 10:08:25 AM
Click here for information on EDACS Wide and Narrow
of a basic EDACS SCAT system.
menu and choose New System .
Edit Name
Program System
Option name
Required
Recommended
systems. Below is an example of an EDACS SCAT system from
(Click here
for a legend of the diagram.)
(click here for information on using the
if you want to change it.
menu. If necessary, the sub-menu and option name on each scanner are listed beside the property.
menu):
Hide quick links:
Advertisement
Table of Contents
