Configuring Tone Out Channels - Uniden BCD996XT User Manual

file:///C|/Documents%20and%20Settings/POpitz/My%20Documents/temp/UnidenManBeta/ToneOutMode.html
Tone Out mode
To determine whether the information on this page applies to your scanner,
see the tags at the bottom of the page.
With the tone out feature, the scanner monitors up to 10 different channels for paging tones
(two-tone sequential, single tone, and group tone). Normally, the scanner monitors each of
the 10 channels in turn. However, if any tone-out channels share the same frequency,
modulator, and attenuator settings, the scanner checks these channels simultaneously.

Configuring Tone Out channels

To configure Tone-Out channels:
1. Go to the
2. Select Tone-Out Setup .
3. Select the Tone-Out channel ( Tone-Out 1 through Tone-Out 10 ) you want to
configure.
4. Select Set Frequencies and choose the frequencies for this channel
5. Select Set Tone and program Tone A and Tone B.
6. Set any of the other properties as you prefer (they aren't required).
Required
Recommended
Optional
file:///C|/Documents%20and%20Settings/POpitz/My%20Documents/temp/UnidenManBeta/ToneOutMode.html (1 of 4)4/7/2009 10:09:01 AM
Tone-Out for... menu.
Frequencies ( Set Frequencies)
Tone A and Tone B (
Name ( Edit Name)
Automatic Gain Control (
*
Delay Time ( Set Delay
Alert ( Set Alert)
Set Tones)
Set Audio AGC)
Time)