Removal Of The Cylinder - PEUGEOT 50 CC Workshop Manual

DISASSEMBLY
Note: When re-installing, lubricate the
2 half cones (6) so as to hold them in
the groove of the valve's stem.
- Placing the 2 half cones (6) into the cup using
the tool shall not be done forcefully when
decompressing the spring (7).
When re-installing, the camshaft bearings, the rocker shafts and the contact between the rockers
and the valves shall well lubricated in order to avoid any risk of seizure when starting the engine
(use a Molykote type grease). Seals and valve stems must be lubricated.

Removal of the cylinder.

- Remove the cylinder (1).
- Remove the base gasket (2) and the
2 centring pillars (3).
- Remove the screw which secures (4) the
chain tensioner slipper (5) (check the
condition of the O-ring and change it if
necessary).
- Remove the chain tensioner slipper.
Tightening torque: 1 m.daN.
16
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
6
7