Removal Of The Intake Pipe; Removal Of The Cooling Volutes - PEUGEOT 50 CC Workshop Manual

Removal of the starter motor.
- Remove the 2 fixing bolts (1).
- Remove the starter motor (2).
Tightening torque: 1 m.daN.
Note: Check the condition of the starter
motor O-ring.

Removal of the intake pipe.

- Remove the 2 nuts that secure the intake
pipe (1).
- Remove the intake pipe and its plastic spacer.
- ve the 2 O-rings.
Tightening torque: 1 m.daN.
Note: Change the O-rings if necessary.

Removal of the cooling volutes.

- Remove the 4 screws (1) that secure the
volute on the flywheel magneto side.
- Remove the volute (2).
- Remove the fastening screw (3).
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
1
2
1
2
DISASSEMBLY
1
3
9