Complete Installation Checklist - Whirlpool WED6605MW Owner's Manual

15. Adjust leveling feet
If washer is not level, use a 9/16" (14.3 mm) open-end or
adjustable wrench to turn jam nuts clockwise on feet until
they are about 1/2" (13 mm) from the washer cabinet. Then
turn the leveling foot clockwise to lower the washer or
counterclockwise to raise the washer. Do not exceed
2" (50 mm) from bottom of foot to bottom of cabinet. Recheck
levelness of washer and that all four feet are firmly in contact
with the floor. Repeat as needed.
HELPFUL TIP: You may want to prop up front of washer
about 4" (102 mm) with a wood block or similar object that
will support weight of washer.
16. Tighten leveling feet
When washer is level and all four feet are firmly in contact
with the floor, use a 9/16" (14.3 mm) open-end or adjustable
wrench to turn jam nuts counterclockwise on leveling feet
tightly against washer cabinet.
HELPFUL TIP: You may want to prop washer again with a
wooden block.
16
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
17. Plug into a grounded 3 prong outlet

Complete Installation Checklist

� Check electrical requirements. Be sure you have correct
electrical supply and recommended grounding method.
� Check that all parts are now installed. If there is an extra part,
go back through steps to see what was skipped.
� Check that you have all of your tools.
� Check that shipping materials were completely removed from
washer.
� Check that the washer is level.
� Check that water faucets are on.
� Check for leaks around faucets and inlet hoses.
� Remove protective film from console and any tape remaining
on washer.
� Check that washer is plugged into a grounded 3-prong outlet.
� Dispose of/recycle all packaging materials.
� Read the "Washer Maintenance and Care" section.
� To test and clean your washer, press Power and choose the
Quick cycle and run it without clothes. Use only HE detergent.
Use 1/2 the manufacturer's recommended amount for a
medium-size load.