Faxing Problems Solution Chart - Xerox CopyCentre C20 User Manual

PROBLEM
Configured Already
Invalid Login

Faxing Problems Solution Chart

Originals are fed diagonally
(skewed)
The original is not being printed
on the paper of the remote Fax
even though it is being sent
Originals are not sent even if
operations are carried out
normally
Originals cannot be received
even if [Start] is pressed
Paper is not collated
Xerox CopyCentre C20, WorkCentre M20 and WorkCentre M20i User Guide
Downloaded From ManualsPrinter.com Manuals
PROBABLE CAUSE
Displayed when an
attempt is made to
configure and already
configured Group.
Displayed when Login
and/or password are
invalid or do not
correspond.
PROBLEM
Ensure the login information and password are
valid and entered accurately.
SUGGESTED SOLUTION
Ensure the Document Guides are adjusted to the width of the
original being fed.
Check the original meets the conditions established for use with
this device.
Ensure the originals were placed face-up in the Document Feeder
or face-down on the Document Glass.
Check that the remote Fax is compatible with the machine. This
machine supports G3 communications but not G4
communications.
Ensure the bell rings before picking up the handset.
Ensure the handset is not replaced before pressing [Start]. When
answering a call using the handset and a Fax is being received, do
not replace the handset until [Start] is pressed and the phone line
switches to the machine.
Check the telephone cord has not been disconnected.
Check the power plug has not been unplugged from the power
outlet.
Check with the party trying to send the original that there are no
problems with the remote fax.
Ensure the machine has paper loaded.
Check if a paper jam has occurred.
SUGGESTED SOLUTION
Page 11-19