Installing Software - Xerox CopyCentre C20 User Manual

Installing Software

Xerox CopyCentre C20, WorkCentre M20 and WorkCentre M20i User Guide
Downloaded From ManualsPrinter.com Manuals
There are four drivers provided:
- PCL5
- PostScript
- Twain
- ControlCentre
The installation procedure is the same for all of them. You can install all of the drivers at the
same time or as many as you require.
These instructions are for installing direct printing and scanning via the parallel or USB. For
Xerox WorkCentre M20i network connections, it is recommended that you contact your System
Administrator or refer to the System Administration Guide.
The Xerox WorkCentre M20 and M20i can be connected directly to the USB or Parallel Port
of a host Workstation. A document file can be sent or received from the host Workstation via
the appropriate port to the Xerox WorkCentre M20 or M20i.
Prior to installing the drivers, ensure the USB or Parallel Port connection has been made
between the Xerox WorkCentre M20 or M20i and the Workstation.
For USB or Parallel Port connection instructions, refer to "Making Connections" starting on page
2-12.
There are three stages required to installing the machine on a port on a local workstation:
Install the driver.
This requires the appropriate printer driver to be installed on the workstation.
Workstation Setup
This requires the workstation to be configured to print to the WorkCentre M20i.
Test Print or Scan
A print job should be submitted to ensure the WorkCentre M20i has been installed and
configured correctly.
Page 2-23