Configuring Ldap Authentication - Motorola AP-51 series Product Reference Manual

WARNING! If you have imported a Server or CA certificate, the certificate will not
4. Use the Radius Client Authentication
on the subnet or host attempting to authenticate with the Radius server. Use the
to add entries to the list. Modify the following information as needed within the table.
Subnet/Host
Netmask
Shared Secret
5. Click Apply to save any changes to the Radius Server screen. Navigating away from the
screen without clicking Apply results in all changes to the screen being lost.
6. Click Undo Changes
settings displayed on the Radius Server screen to the last saved configuration.
7. Click Logout
logout before the applet is closed.

6.14.2 Configuring LDAP Authentication

When the Radius Data Source is set to use an external LDAP server (see
Server on page 6-64), the
To configure the LDAP server:
1. Select
System Configuration
the menu tree.
be saved when updating the access point's firmware. Export your
certificates before upgrading the access point's firmware. From the
access point CLI, use the
export the certificate to a secure location.
Defines the IP address of the subnet or host that will be
authenticating with the Radius server. If a WLAN has been created
to support mesh networking, then enter the IP address of mesh
client bridge in order for the MU to authenticate with a base bridge.
Defines the netmask (subnet mask) of the subnet or host
authenticating with the Radius server.
Click the Passwords button and set a shared secret used for each
host or subnet authenticating against the RADIUS server. The
shared secret can be up to 7 characters in length.
(if necessary) to undo any changes made. Undo Changes reverts the
to securely exit the Access Point applet. A prompt displays confirming the
screen is used to configure the properties of the external LDAP server.
LDAP
-> User Authentication
Configuring Access Point Security
admin(system.cmgr)> expcert
table to configure multiple shared secrets based
-> RADIUS Server
command to
button
Add
Configuring the Radius
-> LDAP from
6-67