Resetting The Access Point Password; Enabling Authentication And Encryption Schemes - Motorola AP-51 series Product Reference Manual

6.2.1 Resetting the Access Point Password

The access point has a means of restoring its password to its default value. Doing so also reverts the
access point's security, radio and power management configuration to their default settings. Only an
installation professional should reset the access point's password and promptly define a new
restrictive password.
To contact Motorola Support in the event of a password reset requirement, go to:
http://www.symbol.com/contactsupport
CAUTION Only a qualified installation professional should set or restore the

6.3 Enabling Authentication and Encryption Schemes

To complement the built-in firewall filters on the WAN side of the access point, the WLAN side of the
access point supports authentication and encryption schemes. Authentication is a challenge-
response procedure for validating user credentials such as username, password, and sometimes
secret-key information. The access point provides two schemes for authenticating users: 802.1x EAP
and Kerberos.
Encryption applies a specific algorithm to alter its appearance and prevent unauthorized reading.
Decryption applies the algorithm in reverse to restore the data to its original form. Sender and
receiver must employ the same encryption/decryption method to interoperate.
Wired Equivalent Privacy (WEP) is available in two encryption modes: 40 bit (also called WEP 64) and
104 bit (also called WEP 128). The 104-bit encryption mode provides a longer algorithm (better
security) that takes longer to decode (hack) than the 40-bit encryption mode.
Each WLAN (16 WLANs available in total to an access point regardless of the model) can have a
separate security policy. However, more than one WLAN can use the same security policy. Therefore,
to avoid confusion, do not name security policies the same name as WLANs. Once security policies
have been created, they are selectable within the
existing default security policy does not satisfy the data protection requirements of a specific WLAN,
a new security policy (using the authentication and encryption schemes discussed above) can be
created.
To enable an existing WLAN security policy or create a new policy:
access point's radio and power management configuration in the
event of a password reset.
Configuring Access Point Security
Security field of each WLAN screen. If the
6-5