Hyundai HY2524 User Manual page 9

There will be a risk of inhaling noxious fumes, mists and vapours.
5.2 Safety instructions for the operation of the compressed air and blow guns.
5.2.1 The compressor reaches a high temperature during operation. Touching it when
hot can lead to burns.
5.2.2 The compressor must not be allowed to take in impurities in the air; otherwise it
will lead to fire or explosion.
5.2.3 When loosening the hose coupling, it should be held by both hands to avoid
injury.
5.2.4 When operating the blow gun, safety glasses MUST be worn. The flying foreign
objects and parts can lead to injury.
5.2.5 Any person in operating the blow gun should wear the protective clothing.
5.3 Safety when spraying paint.
5.3.1 Do not use paints or solvents with a flash point less than 21 ℃.
5.3.2 Paints and solvents must not be heated.
5.3.3 To avoid inhaling harmful liquid vapours you MUST wear face mask protection.
You should adhere to the information provided by the manufacturers of these devices
for additional measures.
5.3.4 DO NOT smoke in the working area and whilst using the compressor.
5.3.5 DO NOT allow any sources of ignition such as matches, lighters, naked flames and
any other sources of ignition such as sparks from grinding etc.
5.3.6 DO NOT eat or drink the work area.
5.3.7 Paint fumes are harmful. The work area must be greater than 30 m2 and it is
necessary to ensure the sufficient air exchange during spraying and drying. Do not spray
against the wind. Always pay attention when spraying on the flammable or dangerous
goods, spraying must be carried out with regard to all safety regulations..
5.3.8 DO NOT allow PVC hoses to come into contact with white spirit, butyl alcohol and
methylene chloride, it will cause a reduced lifetime.
5.4 Pressure tank.
5.4.1 The tank should be kept in good conditions. Monitor any damage. Any necessary
maintenance and repair work must be done without delay and necessary safety
measures to prevent use until repairs take place should be taken.
5.4.2 DO NOT use the tank if it is damaged or has any defects.
5.4.3 The tank should be regularly checked for damage or corrosion. When any damage
or corrosion is found you MUST stop using machine until repair/s have been carried out.
Page 9 Rev 2