Epson L800 Service Manual page 48

L800/L801
5. Disconnect the PF Encoder FFC from the PF Encoder.
6. Remove the two screws, disengage the two hooks of the Cable Holder Frame
from the Front Frame and Main Frame, and remove the Cable Holder Frame.
7. Screw : C.B.S. M3x6 (tightening torque: 7-9 kgf.cm)
(The numbers shown in the figure indicate the order of tightening the screws.)
Hook
Figure 1-75. Removing the Cable Holder Frame
8. Peel off the PF Encoder FFC from the back of the Cable Holder Frame.
Cable Holder Frame
Cable Holder Frame
Figure 1-76. Removing the PF Encoder FFC
Disassembly/Reassembly
Downloaded from www.Manualslib.com
Cable Holder Frame
[Back Side]
1
[Back Side]
Reference Line PF Encoder FFC
manuals search engine
9. Peel off the acetate tape to release the CDR Sensor Cable, and then remove
the screws on the right and left sides, and remove the Front Frame.
Screw
(The numbers shown in the figure indicate the order of tightening the screws.)
1
2
PF Encoder FFC
10. Release the CDR Sensor Cable from the cable guide of the EJ Frame Assy.
11. Remove the EJ Frame Assy.
EJ Frame Assy
: C.B.S. M3x6 (tightening torque: 7-9 kgf.cm)
Front Frame
Acetate Tape
Figure 1-77. Removing the Front Frame
Removal Direction
EJ Frame Assy
CDR Sensor Cable
Cable Guide
Figure 1-78. Removing the EJ Frame Assy
Revision A
2
Positioning hole
and Guide Pin
47
Confidential