Epson L800 Service Manual page 94

L800/L801
Contact point between CR
Unit and CR Guide Shaft (1)
CR Shaft
Application Point
Figure 3-12. Lubrication of the CR Guide Shaft (1)
Contact point between CR Unit
and CR Guide Shaft (2)
CR Shaft
Application Point: Apply from the holes
Figure 3-13. Lubrication of the CR Guide Shaft (2)
Maintenance
Downloaded from www.Manualslib.com
<Lubrication Points>
Contact point between CR Unit and the
CR Guide Shaft
<Type>
G-71
<Application Amount>
210 ± 20mg x 2 points
<Application Timing>
Apply before installing the CR Unit
<Remarks>
Apply with Injector
¸
After lubrication, move the CR
Guide Shaft to left and right by
60mm while rotating it, to spread the
grease evenly.
¸
Make sure that the Timing Belt is
free from grease.
<Lubrication Points>
Lubrication holes of the CR Unit
<Type>
G-71
<Application Amount>
210 ± 20mg x 2 points
<Application Timing>
Apply before installing the CR Unit
<Remarks>
Apply with Injector
¸
Apply grease from the two
lubrication holes.
¸
Make sure that the Timing Belt is
free from grease.
manuals search engine
LUBRICATION OF INK SYSTEM
Contact point between
Main Frame and I/S
Application Point
Figure 3-14. Lubrication of the I/S
LUBRICATION OF APG UNIT
Shafts on APG Unit
Application Point
Figure 3-15. Lubrication of the APG Unit (1)
Overview
<Lubrication Points>
On the Main Frame where the clutch
gear and spring of the Ink System
contact
<Type>
G-71
<Application Amount>
ø 1 x 1 circle
<Application Timing>
Apply before installing the Ink System
<Remarks>
Apply with Injector
<Lubrication Points>
Around the upper part of the shafts on
the APG Unit. (5 points)
<Type>
Shaft
G-71
<Application Amount>
ø 1 x 1 circle x 5 points
<Application Timing>
Disassemble the APG Unit to apply the
grease before installing it.
Application
Point
<Remarks>
Apply with Injector
Revision A
93
Confidential