Epson L800 Service Manual page 59

L800/L801
2. Disconnect the connector of the PE Sensor Cable on the rear side of the
printer.
3. Remove the screw that secures the Front Paper Guide Assy.
Screw : C.B.S. M3x6 (tightening torque: 7-9 kgf.cm)
Connector
PE Sensor Cable
Figure 1-109. Removing the PE Sensor Cable
4. Pull out the EJ Ground Spring to the front side.
Front Paper Guide Assy
Figure 1-110. Removing the EJ Ground Spring
Disassembly/Reassembly
Downloaded from www.Manualslib.com
Front Paper Guide Assy
EJ Ground Spring
manuals search engine
5. Remove the Front Paper Guide Assy, following the steps below.
(1) Lift
(2) Slide the assy leftward little by little to disengage the right side of the assy.
(3) Remove the Front Paper Guide Assy while releasing its shaft from the cutout
of the rib on the left side of the Main Frame.
2
Figure 1-111. Removing the Front Paper Guide Assy
̈
Lubrication is required. See the page given below for the
lubrication information.
Lubrication of Front Paper Guide Assy (p.91)
Front Paper Guide Assy
part to disengage the left side of the Front Paper Guide Assy.
Cutout Front Paper Guide Assy
1
Removal Direction
2
Revision A
58
Confidential