Ink System - Epson L800 Service Manual

L800/L801

1.5.8 Ink System

̈
Take extra care not to spill ink and contaminate the
C A U T I O N
surroundings. Also, when removing the Waste Ink Tube, be
careful not to spill the ink.
̈
Extra care must be taken to avoid injury from sharp edges of
the rib of the Main Frame.
̈
Be careful not to drop and damage the shaft of the Carriage
Lock and the Torsion Spring, as they easily come off.
Pump Section Pump Section
¸ Removal procedure
See the section given below on how to unlock the carriage.
C H E C K
P O I N T
"1.1.6 How to Unlock the Carriage"
Disassembly/Reassembly
Downloaded from www.Manualslib.com
Torsion Spring
Shaft of the
Carriage Lock
Figure 1-69. Ink System
manuals search engine
1. Move the CR Unit to the center.
2. Remove the screw (1) that secures the Cap section.
Screw : C.B.S. M3x6 (tightening torque: 7-9 kgf.cm)
(The numbers shown in the figure indicate the order of tightening the screws.)
3. Insert a screwdriver through the hole of the Main Frame and remove the screw
(2) that secures the Pump section.
Screw : C.B.S. M3x6 (tightening torque: 7-9 kgf.cm)
(The numbers shown in the figure indicate the order of tightening the screws.)
1
Cap section
Figure 1-70. Removing the Ink System (1)
4. Slide the Ink System to the direction of the arrow and disengage the Ink
System from the guide pin of the ASF Unit.
Cap
Figure 1-71. Removing the Ink System (2)
Ink System
Revision A
Hole
2
[Rear Side]
Guide Pin
Pump
45
Confidential