Table of Contents
Advertisement
The system board supports IrDA function for wireless connectivity
between your computer and peripheral devices. You may not use
IrDA (J17) and the COM 2 (J5) serial port at the same time. If you
are using the COM 2 serial por t, make sure this field is set to
Normal.
To use the IrDA function, follow the steps below.
1. Connect your IrDA cable to connector J17 on the system board.
2. Set the “UART2 Mode Select” field to the type of IrDA standard
supported by your IrDA peripheral/device (IrDA or ASKIR). For
better transmission of data, your IrDA peripheral device must be
o
within a 30
angle and within a distance of 1 meter.
3. Set the “RxD TxD Active” and “IR Transmission Delay” fields
appropriately.
The options are Hi, Lo; Lo, Hi; Lo, Lo; and Hi, Hi.
If this option is Enabled, transmission of data will be slower. This is
recommended when you encounter transmission problem with your
device. The options are: Enabled and Disabled.
378/IRQ7, 3BC/IRQ7, 278/IRQ5
IRQ for the onboard parallel port.
Disabled
Disables the onboard parallel por t.
The options are Normal, SPP, EPP, ECP and ECP+EPP. These apply
to standard specifications and will depend on the type and speed
of your device. Refer to your peripheral’s manual for the best option.
Award BIOS Setup Utility
Selects the I/O address and
3
75
Advertisement
Table of Contents
