Table of Contents
Advertisement
3
Award BIOS Setup Utility
This field is used to select the clock speed of the DDR SDRAM
DIMM.
By SPD
100 MHz
133 MHz
This field is used to select the timing of the DRAM.
By SPD
Manual
This field is used to select the clock cycle of the SDRAM CAS
latency time. The option selected specifies the time before SDRAM
starts a read command after receiving it.
The options are Enabled and Disabled.
The options are 2T and 3T.
66
The EEPROM on a DDR SDRAM DIMM has SPD
(Serial Presence Detect) data structure that stores
information about the module such as the memor y
type, memory size, memor y speed, etc. When this
option is selected, the system will run according to
the information in the EEPROM.
The memory clock speed will run at 200MHz.
The memory clock speed will run at 266MHz.
The EEPROM on a DIMM has SPD (Serial Presence
Detect) data structure that stores information about
the module such as the memory type, memory size,
memory speed, etc. When this option is selected,
the system will run according to the information in
the EEPROM.
It allows you to configure the next 5 fields (“DRAM
CAS Latency” to “Active to CMD (Trcd)”. The
system will run according to the settings in these
fields.
Advertisement
Table of Contents
