Setting Netbeui Environment - Oki OKILAN 3100e User Manual

Status
NetWare R-Printer Mode Status
EtherTalk Status
EXIT
Type "4" and press the Enter key. Then the current
settings are displayed.
2. Change the settings.
OkiPage> set protocol [Enter]
<<Protocol setting>>
<Select Protocol>
TCP/IP=1 NetWare=2 EtherTalk=3 EXIT=0 : 3 [Enter]
Will you use EtherTalk? (y/n) : y [Enter]
Enter "n" if you will not use EtherTalk
AppleTalk Zone Name (1-32char) : * [Enter]
AppleTalk Printer name (1-32char) : OKIPAGE 14i
Are you re-setting? (y/n) : n [Enter]
OkiPage> logout (or exit, quit) [Enter]
Enter an appropriate command without logging
out, if you want to set other protocols.

Setting NetBEUI environment

Display/set the NetBEUI environment.
Display Command to use:
shpro
Target account:
Chapter 4 - Administrating Network Printers
- - '2'
- - '3'
- - '4'
- - '0'
show protocol or
General users and
administrator user
Set Command to use:
Target account:
The NetBEUI environment has the following items to be set:
NetBIOS Computer Name: Set the name of the
printer.
NetBIOS Workgroup Name: Specify the workgroup
to which the printer belongs.
NetBIOS Comment: Set the explanation of the printer.
Setting procedure
Here, the setting procedure is explained using an example and
using the setting values shown below:
NetBIOS Computer name: OP04106C
NetBIOS Workgroup name: OKIDATA04106C
NetBIOS Comment:
1. Confirm the current settings.
OkiPage>show protocol.
<<Protocol Status>>
NetWare Q-Server Mode (bindery) Status
NetWare Q-Server Mode (NDS) Status
NetWare R-Printer Mode Status
EtherTalk Status
NetBEUI Status
SNMP Status
EXIT
Type "5" and press the Enter key. Then the current
settings are displayed.
English
set protocol or sepro
Administrator user
OKIDATA Print Server
'1'
- - '2'
- - '3'
- - '4'
- - '5'
- - '6'
- - '0'
51