Oki OKILAN 3100e User Manual page 52

Category
System Contact
System Name
System Location
Trap Community
SNMP
Trap Destination
Trap Usage
Trap events
Telnet provides the following commands:
Command Abbreviation
show address shaddr
show connection shconn
show queue shq/lpq
show status shstat
show protocol shpro
set address seaddr
set address ip seaddr ip
set address mask seaddr mask
set address gateway seaddr gate
set protocol sepro
switch user su
kill kill
reset reset
help help
quit logout/exit
46
Item
Own contact name
Own name information
Own location information
Set strings to set to trap message
Trap destination address
Trap Enable/Disable
Set the events to set to Trap message
Meaning Restrictions
Display all addresses
Display all connections
Display print queue
Display status
Display protocol setting
All address settings root only
IP address setting root only
Subnet mask setting root only
Gateway setting root only
Protocol info setting root only
Switch user
Kill connection root only
reset connection root only
Display command help
Exit from Telnet
Meaning
1 - 47 characters. Default: Blank
1 - 47 characters. Default: Blank
1 - 47 characters. Default: Blank
1 - 32 characters. Default: Public
1 - 6 Destinations
ENABLE/DISABLE
ON-LINE/OFF-LINE/Paper Out/Paper Jam/Cover
Open/Printer error
• After the settings are made with the set
command, they become valid when you log out
the Telnet.
• The kill command severs the connection with the
Connection No that has been specified with N of
"kill N". The executed command becomes valid
when this command ends.
• The reset command forcefully severs all the
connections that are currently connected and
initializes. This command becomes valid when
you log out the Telnet. The execution of this
command affects the use of this network card
significantly. Therefore, exercise caution in
executing this command.
Next, the operation procedure of the Telnet Client is
explained. Here, an example is given in which Telnet is
Range
OkiLAN 3100e Network Card