Hull; Jet Pump Water Intakes; Bilge; Battery - Sea-doo Speedster 200 Operator's Manual

Hull

Inspect hull for cracks or damage.

Jet Pump Water Intakes

Remove weeds, shells, debris or any-
thing else that could restrict the flow
of water and damage the cooling sys-
tems or propulsion units. Clean as nec-
essary. If any obstruction cannot be re-
moved, refer to an authorized Sea-Doo
sport boat dealer for servicing.
F04J1LY
TYPICAL
1. Inspect this area
Inspect leading edges of the impellers,
for nicks or bends, which greatly re-
duce performance of the boat.

Bilge

If water is present in the bilge, turn on
pump switch to empty the bilge.
WARNING
Make sure drain plug is properly
secured before launching the boat
in water.

Battery

WARNING
Verify tightness of battery cables
to their posts and condition of re-
taining straps/fasteners. Do not
charge or boost battery while in-
stalled in engine compartment.
64

Fuel Tank/Oil Levels

With the boat horizontal, fill the fuel tank.
Check the oil level in each engine and re-
fill as necessary.
Check fuel tank retaining straps/fasteners.

Engine Compartment

If any leaks or gasoline odors are
present, do not start the engines.
Consult an authorized Sea-Doo
sport boat dealer.
In order to avoid potential burns, do
not remove the radiator cap or loos-
en the engine drain plug if an en-
gine is still hot.

Fire Extinguisher

1
Make sure fire extinguisher is full, in
good condition and well secured.

Steering System

Have another person help check steer-
ing operation for free movement. When
the steering is centered, the jet pump
nozzles should be in the straight ahead
position. Ensure the jet pump nozzles
pivot easily while steering is turned.
Check operation of steering and
corresponding steering nozzles
before starting engines.

Throttle System

Check throttle levers for free and
smooth operation.
Check operation of throttle levers
before starting the engines.
WARNING
WARNING
WARNING
WARNING