Operating Instructions; Launching/Loading; Trailering - Sea-doo Speedster 200 Operator's Manual

OPERATING INSTRUCTIONS

WARNING
Always perform PRE-OPERATION
CHECKS before operating the boat.
Become thoroughly familiar with
all controls and the function of
each. Should any control or instruc-
tion be not fully understood, refer
to an authorized Sea-Doo sport
boat dealer.

Launching/Loading

CAUTION: Before launching the
boat, ensure the main battery cut-off
switch is turned ON and the bilge
plug is fully screwed into place.
Before loading or launching the boat
on/from the trailer, ensure that the ICS
(Inlet Clearance System) is completely
in the up position, eliminating the pos-
sibility of contact with the trailer.
CAUTION: Loading/launching the
boat on/from the trailer with the wa-
ter intake grate in lower position will
cause damage to the ICS and possi-
bly to the fiberglass hull.
2
F04J2UY
TYPICAL — WRONG POSITION
1. Trailer frame
2. Grate in fully open position
66
F04J2XY
TYPICAL — CORRECT POSITION
1. Trailer frame
2. Grate in fully close position
When finished loading the boat on
trailer, turn the main battery cut-off
switch to OFF.
Remove bilge plug to drain bilge when
boat is on trailer.

Trailering

Refer to the trailer instructions for
proper capacity, operation, mainte-
nance, accessories and warranty.
Check the regulations in your area con-
cerning towing a trailer, especially the
following rules:
– brake system
– tow vehicle weight
– mirrors.
NOTE: An optional brake system is
available for your trailer, contact Karavan
1
Trailers (www.karavantrailers.com).
Take the following precautions when
trailering the boat:
Tie the boat to both bow and stern
(front/rear) eyelets so that it is firmly
retained on the trailer.
– Remove stern light (if installed).
– Ensure that ski post is pushed down.
– Ensure all storage compartment cov-
ers are properly latched.
2
1