DCS WODV230 User Manual page 37

Changing the oven light bulbs
The oven is illuminated by three 12 volt/20 watt halogen bulbs. These have a very long
life, but if you should need to replace one, use only a replacement bulb purchased from
your nearest DCS by Fisher & Paykel dealer and follow these steps:
1 Allow the oven to cool and then turn it off at the wall.
2 Take out the shelves and side racks (see 'Removing and replacing the sliding shelves
and side racks') and use a small flat-head screwdriver to twist and lift the retainer clip
at the top of the glass light cover while holding the glass to prevent it falling. The clip
pivots counter-clockwise (see the diagram).
3 Carefully lift the glass cover out of the lower support and pull out the faulty bulb.
4 Holding the replacement bulb in a soft cloth or tissue (touching the bulb will reduce its
life span), insert the new bulb.
5 Reposition the glass cover and twist the top clip back in place. The procedure is the
same for the light in the roof of the oven cavity.
Note: oven bulb replacement is not covered by your warranty.
Retainer clip
Sockets for
the pins
CARE AND CLEANING
Plate glass cover
Pins
Replacement bulb
33