Rear Roller Removal - Matrix T7xe-04 Service Manual

CHaPTer 9: ParT rePlaCemeNT GUide
9.2 rear roller rePlaCemeNT
1) Turn off power to the unit and disconnect the cord from the machine.
2) Remove one of the end caps using a Phillips screwdriver (Figure A).
3) Remove both roller adjustment screws using an 8 mm Allen wrench (Figure B).
fiGUre a
fiGUre b
4) Remove the roller from the running belt (Figures C & D).
fiGUre C
fiGUre d
5) Reverse Steps 1-4 to install a new rear roller.
6) Tension the running belt as outlined in Section 3.6.
46