Console Replacement - Matrix T7xe-04 Service Manual

CHaPTer 9: ParT rePlaCemeNT GUide

9.12 CoNSole rePlaCemeNT

1) Turn off the power and disconnect the cord from the machine.
2) Remove the 4 screws holding the console back to the front (Figure A).
3) Lean the console back away from the console and disconnect the coax cable connection.
4) Remove the six 6 mm screws from underneath the console. There are arrows stamped in the plastic at the proper openings (Figure B).
fiGUre a fiGUre b
5) Disconnect the remaining connectors holding the console to the frame and remove the console.
6) Reverse Steps 1-5 to install a new console. NOTE: Be sure to re-connect any wire connections removed in Steps 3 and 5 (Figure C).
fiGUre C
7) Auto Calibration must ALWAYS be run after replacing the console (see Section 3.5).
57