Table of Contents
Advertisement
Quick Links
A U T O M A T I C T R A N S M I S S I O N M U L T I - C H A N N E L R E M O T E S T A R T E R S Y S T E M
AS-1414iHF/ AS-
User Guide
It is the responsibility of the vehicle operator to ensure
their vehicle is parked in a safe and responsible manner.
1. When leaving the vehicle, it is the user's
responsibility to ensure that the gearshift lever is in
"Park" in order to avoid accidents upon remote starting.
2. It is the user's responsibility to ensure that the remote
starter is disabled or put into valet mode before
servicing.
FCC/IC NOTICE:
This device complies with Part 15 of the FCC Rules, and RSS-210 of the IC rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation.
The manufacturer is not responsible for any radio or TV interference caused by unauthorized
modifications to this equipment. Such modifications could void the user's authority to operate the
equipment.
DOC: 1.00
January 25, 2007
1424iHF
WARNING
DL Lp
Manufactured in Canada by Autostart
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Autostart AS-1424iHF
Summary of Contents for Autostart AS-1424iHF
- Page 1 The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user's authority to operate the equipment. DOC: 1.00 January 25, 2007 DL Lp Manufactured in Canada by Autostart...
- Page 2 Please Note: • The AS-1414iHF system is equipped with one 4-button multi-channel transmitter. The AS-1424iHF system is equipped with two • 4-button multi-channel transmitters. Basic Remote Operation The system is equipped with a 4-button multi-channel transmitter.
- Page 3 Vehicle Presets Heater and Heated Seat When leaving the vehicle it is recommended to preset the accessory controls in preparation for the next remote start. Settings for the blower motor (fan), front and rear, as well as heated seats (if equipped) should not be left on .
- Page 4 The parking lights will come on. Remove the key, exit the vehicle and lock the doors (if desired). The engine will continue running and will turn itself off when the pre-programmed run time expires. Valet Modes Ignition Valet The system can be placed in valet mode to disable the remote starting capabilities. If the vehicle needs to be serviced, or if you park it indoors, valet mode will prevent the engine from being accidentally started by remote control.
- Page 5 Panic Mode will automatically shut down after sec. Note: To stop panic mode before the end of its delay, press the button LOCK UNLOCK until the sound signal stops. Cold Weather Mode When cold weather mode is active, the engine starts every 2 hours and runs for 3 minutes (or for 8 minutes with Diesel engines);...
- Page 6 Note: If installed and configured in passive mode at installation, the starter kill feature will rearm automatically 60 seconds after the doors are unlocked. For that reason, you may have to unlock your doors a second time if some time elapses before you actually start the engine.
- Page 7 Multi-car Operation This option allows the owner of two vehicles, both equipped with the same Remote Car Starter model, to control both systems with a single remote control. To control the second vehicle, simultaneously press the button and the button of the function you wish to use. TRUNK Note: Your remote control must be configured for second car operation by the installer.
- Page 8 Autostart will replace the remote starter module free of charge with a new remote starter module. For the second year after the date of manufacture, as specified by the serial number on the module, Autostart will replace the remote starter module free of charge with a repaired or refurbished remote starter module.
Need help?
Do you have a question about the AS-1424iHF and is the answer not in the manual?
Questions and answers